Skip to content
← All case studies

Grocery / Specialty Food Retail

24-Hour Grocery in a Downtown Condominium Podium

No roof to put condensers on, no loading dock, residential units overhead and a condo board as a second landlord. Downtown grocery is a logistics project wearing a refrigeration project's clothes.

Location
Toronto, ON
Size
6,200 sq ft over two levels
Timeline
30 weeks, blueprint to open
Budget band
$1.45M–$1.8M
How the 30 weeks broke down
30 weeks total
  1. Discover & feasibility4 wks
  2. Design & permit7 wks
  3. Construction17 wks
  4. Commission & handover2 wks
View as table
PhaseWeeksShare
Discover & feasibility413%
Design & permit723%
Construction1757%
Commission & handover27%

30 wks

Blueprint to open

2

Approval bodies before the city

24/7

Operating hours from day one

An independent grocery operator with two suburban stores wanted a downtown location. The unit was the retail podium of a residential tower: 4,400 sq ft at grade with another 1,800 in the basement, reachable by one freight elevator. Density on the doorstep, a captive residential customer base in the building itself, and a rent that only worked if the store ran 24 hours.

Everything that makes a plaza grocery straightforward was absent.

The challenge

There was no roof. A suburban grocery puts its refrigeration rack and condensers on the roof of its own unit. Here the roof was forty storeys up and belonged to the condominium corporation. Air-cooled heat rejection at grade was not acceptable to the board on noise grounds, and there was nowhere to put it that was not next to a residential amenity terrace.

That pushed the whole system to a water-cooled design with a glycol loop and a mechanical space in the basement, which is a more expensive system, needs a reliable municipal water or closed-loop arrangement, and takes floor area away from storage in a store that already had none.

There were people living above it. Compressor vibration transfers into structure. A rack running at three in the morning under somebody’s bedroom is a complaint, and in a condominium a complaint is a legal matter, not a service call. Isolation had to be designed, not assumed: inertia bases, spring isolators, flexible connections on every pipe crossing a structural element, and an acoustic consultant’s review before the equipment was ordered.

There was no loading dock. Deliveries went through a shared service bay with a height restriction, a booking system and a residential garbage schedule competing for the same slot. Pallets then travelled down a single freight elevator with weight and dimension limits. That constrains case sizes, walk-in panel dimensions and the refrigeration rack itself — every component had to fit the elevator, which eliminated several otherwise sensible equipment choices and ruled out a packaged rack delivered assembled.

There were two landlords. The commercial owner held the lease, and the condominium corporation held approval over anything touching structure, the building envelope, shared services, noise or the service bay. Two separate submission and approval processes run on different timescales, and neither moves because the other one is finished.

And it never closes. A 24-hour operation cannot be ventilated and conditioned on an occupancy schedule, has after-hours noise exposure, and needs a security and cash-handling design built into the layout rather than added.

What NHFC did

Discover. Four weeks, and it was all capacity and permission. We established what the base building would actually give us — electrical capacity at the unit, available water, the structural allowance for a basement mechanical room, the service bay’s real dimensions — before any layout work. Then we took the refrigeration strategy to the condominium board early, with the acoustic approach included, because that approval was the single item most likely to kill the project and the worst time to find out is after drawings.

The lease was still in negotiation. We used the findings to get the base-building electrical allowance and the service bay access terms written into the lease rather than left to goodwill, and to shift part of the mechanical room cost to the landlord as a permanent improvement.

Design. The store was planned around the elevator. Case runs were broken into lengths that fit, walk-ins were specified as panel systems assembled on site rather than delivered boxes, and the rack was designed to be brought down in sections and built in place.

Norpex handled the case and equipment layout across both levels, with back-of-house, the walk-ins and bulk storage in the basement and the full sales floor at grade. We reconciled it against the glycol piping routes, the elevator constraints and the panel schedule before anything was ordered.

Refrigeration went in as a water-cooled glycol system with the plant in the basement mechanical room, isolated on inertia bases, with every pipe penetration through structure flexibly connected. HVAC was zoned for continuous operation. Drawings went to the city as one coordinated set and to the condominium corporation as a parallel submission.

Build. Pasha Construction worked inside downtown constraints: restricted working hours, no site storage, materials hoisted or elevatored on a booked schedule, and the basement slab work for drainage and the mechanical room done with the building occupied above. Shop Flooring supplied a sealed polished finish for the sales floor and a resinous system for the basement prep and warewashing areas.

The glycol plant assembly and the acoustic isolation were their own tracked critical path, with the acoustic review repeated on the installed system rather than taken on faith from the design.

Deliver. Refrigeration pulled down and temperature-logged across every case and walk-in for 72 hours before product. Vibration and noise measured in the residential unit directly above the mechanical room, with the board’s representative present, and signed off. ESA cleared the distribution, TSSA the gas to the bake-off oven, and Toronto Public Health reviewed and passed the premises including the service deli and bake-off.

The outcome

Thirty weeks and open, running 24 hours from the first day. All-in cost came to roughly $255 per square foot — well above the $165 the same operator’s suburban store cost, and almost none of the difference is equipment. It is the water-cooled plant, the acoustic work, the elevator-constrained logistics and the restricted working hours.

No noise complaint has come from the tower.

The lesson the operator took into their next site: downtown square footage is not expensive because of what you put in it. It is expensive because of how it has to get in there.

Scope at a glance

  • Base-building capacity assessment: electrical, water, structure, service bay dimensions
  • Condominium corporation approval obtained ahead of design, including acoustic strategy
  • Lease negotiation support: electrical allowance, service bay terms, mechanical room cost sharing
  • Water-cooled glycol refrigeration with basement plant in place of rooftop air-cooled
  • Acoustic isolation designed and verified: inertia bases, spring isolators, flexible penetrations
  • Equipment and walk-ins specified to freight elevator weight and dimension limits
  • Rack delivered in sections and assembled in place
  • Two-level layout: sales floor at grade, back-of-house and bulk storage below
  • HVAC zoned for continuous 24-hour operation
  • Security and cash-handling designed into the layout
  • Basement slab work and drainage with the building occupied above
  • Polished sealed sales floor and resinous back-of-house flooring
  • Building permit, parallel condominium submission, ESA, TSSA, Toronto Public Health review
  • 72-hour refrigeration verification and post-installation acoustic sign-off with the board

Free Consultation

Tell us what you want to build.

The first consultation is free. You get a project review, a realistic timeline and a preliminary cost breakdown — including an honest answer if the project does not work as scoped.

Mon – Fri, 9:00 a.m. – 5:00 p.m. · No obligation

Call usStart your project